This instruction show you guide on how to use DDDL engine software to do DPF delete programming for Detroit Diesel DD15 EPA 10.
Procedures:
Connect NEXIQ-2 USB Link to DLC,and then run software.
After identification,select “Parameters”
After all parameters reading done, now you need change some value to perform DPF delete
PGR035-105 D0 Lamp DPF–>”Disabled”
407 D0 Selection High Exhaust Temp–>”Disabled”
PGR046-DPF Veh..Speed Tresh Enable–>”OFF”
DPF Asb Mileage Sync MU–>”Disabled”
PGR002-Doser Pressure Inlet–>”No Installed”
PGR 001_PropValve PWM8 Configuration–>”Not Parameterized”
PGR007_DPF Config-DPF Distance Interval Regen–>”Disabled”
PGR024_Sensor Config-Exhaust Pressure before DPF INLET–>”Not Active”
Outlet Temperature Doc–>”Not Active”
Inter Temperature DOC–>”Not Active”
Outlet Temperature DPF–>”Not Active”
Pressure after DPF Outlet–>”Not Active”
Doser Pressure Outlet–>”Not Active”
PGR007 DPF Config-DPF shutdown enable–>”Disabled”
PGR007_DPF Config DPF Time Interval Regen–>”Disabled”
PGR007_DPF Config DPF Distance Interval Regen–>”Disabled”
PGR007_DPF Config DPF Fuel Interval Regen–>”Disabled”
Then click “Send” button and click “OK” button to continue
After then it will prompt you to enter password to continue
Click “Backdoor” button show you with VIN and Seed value
Run DD Backdoor password KG, and input VIN and Seed, then click “OK” to calculate password.
Copy password paste it to DDDL and click “OK” to continue
Now it will writing parameters just wait process
Done!
Comments